Yang Chun Yi

一、RHEL
1、vim /etc/sysconfig/network-scripts/ifcfg-bond0
DEVICE=bond0
BOOTPROTO=static
BROADCAST=192.168.4.255
IPADDR=192.168.4.100
NETWORK=192.168.4.0
NETMASK=255.255.255.0
GATEWAY=192.168.4.1
ONBOOT=yes

2、vim /etc/sysconfig/network-scripts/ifcfg-eth1
DEVICE=eth1
BOOTPROTO=static
ONBOOT=yes

3、vim /etc/sysconfig/network-scripts/ifcfg-eth2
DEVICE=eth2
BOOTPROTO=static
ONBOOT=yes

4、vim /etc/modprobe.conf(RHEL 5)
vim /etc/modprobe.d/dist.conf(RHEL 6)
加入這兩行
alias bond0 bonding

options bond0 miimon=80 mode=1
#mode=1 自動備援模式，其中一條線若斷線，其他線路將會自動備援
#mode=0 平衡負載模式，有自動備援，但需要"Switch"支援及設定

5、vim /etc/rc.d/rc.local
加入
ifenslave bond0 eth1 eth2


二、SLES
1、vim /etc/sysconfig/network/ifcfg-bond0
BOOTPROTO='static'
BROADCAST='192.168.4.255'
IPADDR='192.168.4.30'
NETWORK='192.168.4.0'
NETMASK='255.255.255.0'
STARTMODE='onboot'
BONDING_MASTER='yes'
BONDING_MODULE_OPTS='mode=0 miimon=100 use_carrier=0'
#BONDING_SLAVE0='bus-pci-0000:00:12.0'
#BONDING_SLAVE1='bus-pci-0000:00:13.0'
BONDING_SLAVE0='eth2'
BONDING_SLAVE1='eth3'

2、vim /etc/sysconfig/network/ifcfg-eth2
BOOTPROTO='none'
BROADCAST=''
ETHTOOL_OPTIONS=''
IPADDR=''
MTU=''
NAME='82572EI Gigabit Ethernet Controller (Copper)'
NETMASK=''
NETWORK=''
REMOTE_IPADDR=''
STARTMODE='off'
USERCONTROL='no'


3、vim /etc/sysconfig/network/ifcfg-eth3
BOOTPROTO='none'
BROADCAST=''
ETHTOOL_OPTIONS=''
IPADDR=''
MTU=''
NAME='82574L Gigabit Network Connection'
NETMASK=''
NETWORK=''
REMOTE_IPADDR=''
STARTMODE='off'
USERCONTROL='no'

4、rcnetwork restart

5、vim /etc/modprobe.conf
加入
alias bond0 bonding
options bond0 miimon=100 mode=1